Nowadays, the mining loader is an indispensable working tool in various engineering projects, but it often encounters many faults when in use. Once there is a fault, it will give customers a headache. The following are the reasons for the automatic falling of the boom of the mining loader:

1、動臂操作滑閥的操縱機構調整不當，使動臂滑閥未能完全處于中位，應檢查操縱機構是否調整在中。

1. The control mechanism of the boom operating spool valve is not adjusted properly, so that the boom spool valve cannot be fully in the middle position. Check whether the control mechanism is adjusted in the middle position.

2、動臂油缸活塞密封圈損壞或油缸缸筒損壞，造成油缸內泄嚴重，應更換密封件或更換動臂油缸。

2. If the piston seal ring of boom cylinder is damaged or the cylinder barrel is damaged, resulting in serious internal leakage of the cylinder, replace the seal or replace the boom cylinder.

3、分配閥動臂滑閥閥桿磨損過度，密封不嚴，應更換分配閥。

3. The valve rod of the boom slide valve of the distribution valve is excessively worn and the seal is not tight. The distribution valve should be replaced.

4、分配閥上的閥損壞，引起內泄。

4. The safety valve on the distribution valve is damaged, causing internal leakage.

以上是對小型裝載機大臂下落原因的分析，希望對廣大客戶有所幫助，還有就是判斷是分配閥還是油缸的原因引起動臂自動下降的方法為：將動臂舉高位置，將動臂閥桿致于中位，聽動臂油缸處有無響聲，如果有嘭、嘭的響聲，則為分配閥有故障，如果沒有響聲，則可能是油缸的問題，應拆檢油缸。

The above is the analysis of the reasons for the fall of the boom of the small loader. I hope it can be helpful to our customers. Also, the method to judge whether it is the distribution valve or the oil cylinder that causes the boom to drop automatically is: lift the boom to the high position, turn the boom valve rod to the middle position, and listen to whether there is a sound at the boom oil cylinder. If there is a bang and bang, the distribution valve is faulty. If there is no sound, It may be a problem with the oil cylinder, and the oil cylinder should be disassembled and inspected.