When the parts of the loader are in bad condition, the water temperature will be too high, the action will be slow, boiling and so on. Now let's analyze and solve the problem of high water temperature of the loader.

裝載機水溫高的原因：

Reasons for high water temperature of loader:

1、裝載機配件節溫器失靈造成水不能經水箱散熱，防凍液比例過低；水中有雜物導致水管堵塞，水箱有水垢，散熱不好加上大負荷工作時間過長。

1. The failure of thermostat of loader accessories results in the water can not be dissipated through the water tank, and the proportion of antifreeze is too low; Debris in the water leads to water pipe blockage, water tank has scale, poor heat dissipation and long working time under heavy load.

2、裝載機配件風扇皮帶松緊度欠佳，風扇損壞，水泵水循環不好，導致裝載機水溫高故障。

2. The belt tightness of the loader accessories fan is not good, the fan is damaged, and the water circulation of the water pump is not good, which leads to the high water temperature fault of the loader.

3、裝載機節溫器故障，水箱臟，導致裝載機水溫過高，點火時間不對，水箱水循環不好散熱器內堵了。

3. The thermostat of the loader fails and the water tank is dirty, which leads to the high water temperature of the loader, the wrong ignition time, the poor water circulation of the water tank and the blockage of the radiator.

4、裝載機發動機故障，也有可能導致裝載機水溫高故障現象的發生。

4. The engine failure of the loader may also lead to the high water temperature of the loader.

裝載機水溫高維修建議：

Maintenance suggestions for high water temperature of loader:

1、出現裝載機水溫高、動作慢現象后，裝載機老師可以拆掉裝載機配件節溫器，檢查裝載機發動機內防凍液的匯兌比例，然后檢查水箱是否有污垢，水箱內水循環是否正常，確認水泵有沒有故障，檢查裝載機的風扇皮帶，發動機有沒有故障。

1. When the water temperature of the loader is high and the action is slow, the loader teacher can first remove the thermostat of the loader accessories, check the proportion of antifreeze in the engine of the loader, then check whether there is dirt in the water tank, whether the water circulation in the water tank is normal, confirm whether the water pump is faulty, and check whether the fan belt and engine of the loader are faulty.

2、裝載機水溫高沸騰，可以先清洗散熱器，然后換一個新的風扇，再調效液壓泵流量，減輕發動機的負荷，再看裝載機水溫高沸騰故障是否排除。另外，出現了裝載機水溫高沸騰現象，需要排查裝載機的水箱，水循環，風扇皮帶松緊程度，點火時間，節溫器等情況是否正常。

2. If the water temperature of the loader is high boiling, you can clean the radiator first, then replace it with a new fan, adjust the flow rate of the hydraulic pump, reduce the load of the engine, and then see if the high boiling fault of the loader water temperature is eliminated. In addition, there is a phenomenon of high boiling water temperature of the loader. It is necessary to check whether the water tank, water circulation, tightness of fan belt, ignition time, thermostat and other conditions of the loader are normal.

3、裝載機出現水溫高等問題，主要原因之一是裝載機配件出現問題，所以在日常操作和護理中，要做好裝載機配件的護理和檢查工作。

3. One of the main reasons for the high water temperature of the loader is the problem of the loader accessories, so in the daily operation and nursing, we should do a good job in the nursing and inspection of the loader accessories.